You are here: Experiment Guide > Imaging Modes > Applications Modules > C-AFM Hardware Selection

C-AFM Hardware Selection

  1. After launching NanoScope, software select Tools > Select Microscope to open the Microscope Select window, shown in Figure 1.

Figure 1: Microscope Select Dialog Box

  1. Click the New button in the Microscope Select dialog box to open the new Equipment dialog box, shown in Figure 2.
NOTE: If you are upgrading your NanoScope software, you can select the Edit button and simply edit an existing profile.

Figure 2: Equipment Dialog Box

  1. Enter a profile description and select the appropriate Controller, Microscope and Vision system.

  2. For Sensor, select C_AFMto indicate the installed application module.
  3. Click OK to close the Equipment panel.
  4. Click OK to close the Microscope Select panel.

 

www.bruker.com Bruker Corporation
www.brukerafmprobes.com 112 Robin Hill Rd.
nanoscaleworld.bruker-axs.com/nanoscaleworld/ Santa Barbara, CA 93117
   
  Customer Support: (800) 873-9750
  Copyright 2010, 2011. All Rights Reserved.