Connect the NanoScope V Controller to a New Adapted SPM

Single-cable (To Controller) SPMs (e.g. MultiMode, EnviroScope) require the use of a 37-pin Adapter (Bruker P/N 37PA), shown in Figure 1, that converts the two connectors on the front of the NanoScope V to one large microscope cable and a smaller sensor cable. Plug the 37-pin adapter into the Low Voltage and High Voltage/Digital connectors on the front of the NanoScope V Controller and tighten the two thumbscrews to secure it. See Figure 2.

Figure 1: Two-cable to one-cable MultiMode Adapter

Figure 2: MultiMode Adapter plugged into the NanoScope V Controller

Figure 3: Two-cable to one-cable 37-pin Adapter

Figure 4: 37-pin Adapter plugged into the NanoScope V Controller

Open topic with navigation