You are here: Experiment Guide > Imaging Modes > Nanomechanical Mapping > Limits Parameters

Limits Parameters

Z Limit

Permits attenuation of maximum allowable Z voltage and vertical scan range to achieve higher resolution (smaller quantization) in the Z direction.

Range or Settings:

NOTE: Show All, discussed in the NanoScope Software Version 8 User Guide, must be enabled to view and edit this parameter.

Z Range

Permits attenuation of the range of the Z piezo as measured by the Z sensor to achieve higher resolution (smaller quantization) in the Z direction.

Range or Settings:

NOTE: The Z Range parameter does not apply to the MultiMode because it does not incorporate a Z sensor.

Deflection Limit

Use this parameter to attenuate the maximum allowable deflection signal to achieve higher resolution. If this value is too small, saturation of the Deflection channel will occur.

Range or Settings: 4.096 V–24.58 V

 

www.bruker.com Bruker Corporation
www.brukerafmprobes.com 112 Robin Hill Rd.
nanoscaleworld.bruker-axs.com/nanoscaleworld/ Santa Barbara, CA 93117
   
  Customer Support: (800) 873-9750
  Copyright 2010, 2011. All Rights Reserved.