You are here: NanoScope Software User Guide > Offline Commands > AutoProgram > Example command: Flatten

Example command: Flatten

To open the Flatten View:

  1. Click the command name or icon that has been added to the Run Group Autoprogram.
  2. Click in the image and drag open a box over features in the image that are to be excluded from the polynomial fit calculations (see Figure 1). Typically, only featureless areas are used for flattening an image.
  3. In the Inputs panel of the Flatten view, set parameter values to apply for all images operated on by the AutoProgram.
  4. Close the Flatten view.
NOTE: Check the box Do not use Default Configuration Settings (see Default Configuration Settings). This setting can affect drawn Stopband boxes and cursors which can be subsequently changed and used for later Autoprograms.

Figure 1: Specify a Flatten Operation

 

www.bruker.com Bruker Corporation
www.brukerafmprobes.com 112 Robin Hill Rd.
nanoscaleworld.bruker-axs.com/nanoscaleworld/ Santa Barbara, CA 93117
   
  Customer Support: (800) 873-9750
  Copyright 2010, 2011. All Rights Reserved.