NanoScope Software Control

NanoScope software is capable of controlling basic functions of the LakeShore 335. Follow the procedure below to enable NanoScope software control of your LakeShore 335.

Configure NanoScope

To enable NanoScope software control of the LakeShore 335:

1. Click Tools > Select Microscope. This will open the Microscope Select window:

2. Click Edit to open the Equipment window:

3. Click Advanced to open the Advanced view:

4. Select LakeShore for the Temperature Controller and click OK to accept your choice and close the Equipment window.
5. Click Serial in the Microscope Select window to open the Serial Port Configuration window:

6. The LakeShore 335 is connected to the computer with a USB interface. Use the Windows Device Manager to determine what virtual port is assigned to the LakeShore 335.
7. Select the appropriate COM port and click Edit to open the Edit Port Setup window:

8. Select LakeShore Temp Controller for the Equipment Type and 57600 for the Baud rate, O (Odd) for Parity, 7 Data bits and 1 Stop bit..
9. Click OK to accept your choice and close the Edit Port Setup window.
10. Click Done to close the Serial Port Configuration window.
11. Click OK to close the Equipment window.
12. Click OK to close the Microscope Select window.

Operating the LakeShore 335 with NanoScope

1. Turn the line power switch, shown in Figure 1, on the back of the LakeShore 335 to On. A Temperature Control panel, shown in Figure 1, will appear in the Scan Parameter list.

Figure 1: The NanoScope Temperature Control panel

2. Set the Proportional, Integral and Derivative Gains to 50, 20 and 1 respectively.
3. Set the Heater Setpoint.
4. Set the Heater Range to High (see ). This turns the LakeShore heater output on.

Figure 2: Set the Heater Range to High.

Open topic with navigation