Dimension Icon: Computer to Controller Cable Connections

+

Figure 1: Cabling Configuration: Dimension Icon

Connection Procedure:

1. Connect the Low Voltage and High Voltage/Digital cables between the NanoScope V Controller and the rear panel of the Dimension Icon Electronics box (E-box).
2. Connect the Closed Loop Scanner cable from the front of the NanoScope V Controller and the rear panel of the Dimension Icon E-box.
3. Plug the DSI cable from your computer into the NanoScope V Controller connector labeled Computer (Expansion on the NanoScope V-PI).
4. Basic installation for the Native SPM is now complete. Proceed to Factory Software Configuration of a New SPM then to NanoScope V Controller Operation.

Open topic with navigation