You are here: NanoScope Software User Guide > Real-time Views > Views for Scanning > Check Initial Scan Parameters

Check Initial Scan Parameters

Click the Check Parameters icon in the Workflow Toolbar to access the Check Parameters view.

The Check Parameters view allows you to see at a glance the default parameters for your current experiment setup (also referred to as a 'workspace'). These were loaded when the user first selected their mode of operation in the See "The Select Experiment Window". These parameters are intended as good starting points for the selected experiment type, but can be modified by the user as required.

NOTE: If the Check Parametersicon is not visible in the Workflow Toolbar, this means that a predefined set of parameters was not installed for the Experiment you have loaded. In this situation, you can check and set parameters prior to engaging by selecting the Scan button from the Workflow Toolbar. The parameter settings in the Scan view will not necessarily reflect the suggested starting scan parameters for your experiment.

Either leave the parameters as-is and continue with your experiment, or change them according to the mode and application that you are attempting. When a parameter is changed from the workspace value it will be highlighted in green as shown in Figure 1. If you want, you can save your changed parameter list as a new workspace (experiment) for future experiments of the same or similar type.

Figure 1: The Check Parameters view

www.bruker.com	Bruker Corporation
www.brukerafmprobes.com	112 Robin Hill Rd.
nanoscaleworld.bruker-axs.com/nanoscaleworld/	Santa Barbara, CA 93117

	Customer Support: (800) 873-9750
	Copyright 2010, 2011. All Rights Reserved.